AL10X5

The end profile AL10X5 creates a discreet and innovative connection between floor covering and wall, window (frame) or stair step – wherever connection and expansion joints have to be adhered to from a structural point of view.

Suitable for:
Parquet, Laminate, design floors and tiles – for floor thicknesses from 5 mm

Zeichnung minileiste AL10X5
minileiste AL10X5-01 Silber

Silver silk matt EV1

minileiste AL10X5-01 Silber

Titanium silk matt C31

minileiste AL10X5-02 Titan

Black silk matt C35

minileiste AL10X5-03 Schwarz

White finely structured RAL 9016

minileiste AL10X5-04 Weiss

Gold silk matt EV3

minileiste AL10X5-05 Gold

Tool-free, quick and easy

Our end profile AL10X5 can be installed easily, without tools and without visible fastening points: No drilling, no screwing, no hammering, no dirt, no noise, no annoyance. Irregularities in the masonry can be easily compensated for by simply attaching additional mounting clips if necessary.

Easy assembly in just 8 steps

Step 1

The width of the connection joint should be between 5 and 13 mm depending on the profile system used (see data sheets). The thickness of the floor covering must also be taken into account. Our X5 systems can be used from a minimum floor covering thickness of 5 mm.

Step 2

The dimensions for the profile cuts are taken from the wall surfaces. Miter cuts for inside and outside corners are taken into account.

Step 3

The profiles are cut to size. The miter cut for the inside or outside corner is made in one operation. The profile is pressed securely onto a wooden support and positioned in the saw so that it is cut. The cutting direction of the saw presses the profile against the wood support during the cutting process.

Step 4

The mounting clips are pushed into the end strip at the front. Attention: Two opposing shoulders are incorporated into the end strip, between which the mounting clips are easily guided.

Step 5

The mounting clips should be pushed into the end strip at a distance of about 30 to 60 cm from one another. Depending on the unevenness in the masonry, individual mounting clips can be installed at closer intervals so that the end strip is flush with the masonry.

Step 6

The end strip with the inserted mounting clips is now brought into the mounting position on the wall surface. With the mounting aid, the mounting clips are carefully spread apart by pressing the mounting clips towards the wall with the mounting aid.

Step ​7

As soon as the clamping process is complete, the end strip is pressed down and the assembly aid removed. Now the tensioning and assembly process is repeated until all assembly clips of an end strip are tensioned and sunk. The end strip can be removed from the connection joint at any time for any corrections.

Step 8

The end strip is installed. After a short check, the next section can be installed.

minileiste Produktkatalog 2022 DE weiss

Catalogs and data sheets in the download area

Here you will find all the important information for download: product catalog, data sheets, assembly instructions, etc.

Request a non-binding offer now

Have we aroused your interest and would you like a personal offer? We look forward to your inquiry.

Angebotsanfrage EN

You are*

Selection of profile*

Colour*

Free sample

Privacy

4 + 11 =

minileiste by ENGELTECH GmbH
Nockhofweg 26h
AT – 6162 Mutters near Innsbruck

Phone: +43 512 319 062

info@minileiste.com
www.minileiste.com

VAT-Nr. ATU68228777

Red Dot Winner 2020 - Best of the best